Crystal UV resin, 25 g

Product detailed description

VIDEO : UV resin hair clips

VIDEO: Resin earrings without mould

With this UV resin you can create the entire product, or you can use it only on the final layer of the product by simply squeezing it out of the tube and curing it under UV light. This eliminates the mixing of ingredients and makes it a great alternative to two-part resin when you only need a small amount, which is very difficult to mix with two-part resin.

Thin layers take approx. 2 minutes to cure, thicker layers up to a maximum width of 3 mm take approx. 4 minutes to cure. The curing time depends directly on the quality and strength of the UV curing lamp, the degree of discolouration and the embedded objects. It is self-levelling, creating a smooth surface.
It cures in direct sunlight for 5-10 minutes, in indirect sunlight for 20-40 minutes.

This resin is designed for layers of maximum 3 mm. If the resin is clear and without embedded objects, it is possible to cure the entire 3 mm. In the case of thicker colouring or insertion of objects through which the light from the UV lamp cannot penetrate, we recommend applying in thinner layers and curing these layers continuously. Depending on the layer and the amount of pigmentation, curing may take longer than the above times.

Curing in moulds that are translucent or illuminated by a UV lamp is ideal. For example, for metal beds, we recommend application in thinner layers.

If the surface remains sticky after curing, we recommend using the UV curing lamp again. Another option is to wipe the surface with a paper towel dipped in acetone or nail polish remover.

Security measures:

• if eyes are hit, flush with plenty of water. Avoid swallowing or inhaling the material. Seek medical attention if swallowed or if mucous membranes are affected;
• wash your hands thoroughly after work, especially before eating. Do not smoke, drink or eat while creating the product;
• work in a well-ventilated area with (important!) low humidity (no more than 30-40%);
• the temperature must not be lower than 20 °C and not higher than 30 °C;
• work only with gloves, the resin can cause an allergic reaction on the skin;
• we recommend protecting your airways with a respirator or full-face mask.